Tescom TC-3000C - Quick Test(OPMOD)

5.3 Reference Guide using RS-232C commands
126
Value
DUT RX Level : -327.68 ~ 20, -20(default)
READ:RFTC:ML:BYTES?
Description
This command reads minimum number of samples(returned payload bytes) to measure BER.
CONF:RFTC:ML:BYTES <Value>
Description
This command writes minimum number of samples(returned payload bytes) to measure BER.
Value
minimum number of samples : 0 ~ 2147000000, 200000(default)
READ:RFTC:ML:BER?
Description
This command reads bit error rate.
5.3.17 Quick Test(OPMOD)
EXEC:RFTC:OPMOD:RUN
Description
This command executes measurement of quick test containg output power, modulation characteristics, initial
carrier frequency, and carrier frequency drift at a time.
EXEC:RFTC:OPMOD:STOP
Description
This command stops execution of quick test(EXEC:RFTC:OPMOD:RUN).
READ:RFTC:OPMOD:CH?
Description
This command reads RX frequency of a tester(TX for a DUT).
CONF:RFTC:OPMOD:CH <Value>
Description
This command writes RX frequency of a tester(TX for a DUT).
Value
channel : RX frequency of a tester (TX for a DUT), 0 ~ 78, 0-39-78(default)
READ:RFTC:OPMOD:PACK_TYPE?
Description
This command reads packet type.
CONF:RFTC:OPMOD:PACK_TYPE <Value>
Description
This command writes packet type.
Value
packet type : LONGEST, DH1(default), AUX1, DH3, DH5
READ:RFTC:OPMOD:PACK_NUM?
Description
This command reads number of packets.