Tescom TC-3000C - EDR Differential Phase Encoding(EDPE)

5.3 Reference Guide using RS-232C commands
135
READ:RFTC:EFSMA:WOI_AV?
Description
This command reads average value of Initial Frequency Error and sum of Block Frequency Error(Wi+W0)
from EDR Carrier Frequency Stability & Modulation Accuracy(TRM/CA/11/C) measurement. Before reading
this value by “READ:RFTC:EFSMA:W0I_AV?” command, “EXEC:RFTC:EFSMA:RUN” command be exected
to update measurement value.
READ:RFTC:EFSMA:RMS_DEVM_MIN?
Description
This command reads minimum value of RMS DEVM from EDR Carrier Frequency Stability & Modulation
Accuracy(TRM/CA/11/C) measurement. Before reading this value by
“READ:RFTC:EFSMA:RMS_DEVM_MIN?” command, “EXEC:RFTC:EFSMA:RUN“ command be exected to
update measurement value.
READ:RFTC:EFSMA:PEAK_DEVM_MIN?
Description
This command reads minimum value of PEAK DEVM from EDR Carrier Frequency Stability & Modulation
Accuracy(TRM/CA/11/C) measurement. Before reading this value by
“READ:RFTC:EFSMA:PEAK_DEVM_MIN?” command, “EXEC:RFTC:EFSMA:RUN” command be exected to
update measurement value.
5.3.21 EDR Differential Phase Encoding(EDPE)
EXEC:RFTC:EDPE:RUN
Description
This command executes EDR Differential Phase Encoding(TRM/CA/12/C) measurement.
EXEC:RFTC:EDPE:STOP
Description
This command stops execution of EDR Differential Phase Encoding(TRM/CA/12/C) measurement. It is used
to cancel the running RF test case which is started by “EXE:RFTC:EDE:RUN” command.
READ:RFTC:EDPE:CH?
Description
This command reads channel value for EDR Differential Phase Encoding(TRM/CA/12/C) measurement.
CONF:RFTC:EDPE:CH <Value>
Description
This command sets channel for EDR Differential Phase Encoding(TRM/CA/12/C) measurement.
Value
channel : 0-39-78(default)
(ex) In case of setting channel 0 : CONF:RFTC:EDPE:CH 0
In case of setting channel 0, 39, 78 : CONF:RFTC:EDPE:CH 0-39-78
READ:RFTC:EDPE:PACK_TYPE?
Description
This command reads packet type for EDR Differential Phase Encoding(TRM/CA/12/C) measurement.
CONF:RFTC:EDPE:PACK_TYPE <Value>
Description
This command sets packet type for EDR Differential Phase Encoding(TRM/CA/12/C) measurement.
Value
Packet type : 2-LONGEST(default),3-LONGEST,2-DH1,3-DH1,2-DH3,3-DH3,2-DH5,3-DH5,2-EV3,3-EV3,2-
EV5,3-2V5