Tescom TC-3000C - Multi Slot Sensitivity(SM)

5.3 Reference Guide using RS-232C commands
123
This command reads hopping mode.
CONF:RFTC:SS:HOP <Value>
Description
This command writes hopping mode.
Value
hopping mode : ON, OFF(default)
READ:RFTC:SS:RX_LEV?
Description
This command reads RX power at the receiver input of the DUT in dBm.
CONF:RFTC:SS:RX_LEV <Value>
Description
This command writes RX power at the receiver input of the DUT in dBm.
Value
DUT RX Level : -327.68 ~ 20
READ:RFTC:SS:BYTES?
Description
This command reads minimum number of samples(returned payload bytes) to measure BER.
CONF:RFTC:SS:BYTES <Value>
Description
This command writes minimum number of samples(returned payload bytes) to measure BER.
Value
minimum number of samples : 0 ~ 2147000000, 200000(default)
READ:RFTC:SS:DIRTY_TX?
Description
This command reads dirty transmitter mode.
CONF:RFTC:SS:DIRTY_TX <Value>
Description
This command writes dirty transmitter mode.
Value
dirty transmitter mode : ON(default), OFF
READ:RFTC:SS:BER?
Description
This command reads bit error rate.
5.3.15 Multi Slot Sensitivity(SM)
EXEC:RFTC:SM:RUN
Description
This command executes measurement of multi slot sensitivity test case(RCV/CA/02/C).
EXEC:RFTC:SM:STOP
Description
This command stops execution of multi slot sensitivity.