Tescom TC-3000C - Page 124

5.3 Reference Guide using RS-232C commands
124
READ:RFTC:SM:CH?
Description
This command reads RX frequency of a tester(TX for a DUT).
CONF:RFTC:SM:CH <Value>
Description
This command writes RX frequency of a tester(TX for a DUT).
Value
channel : RX frequency of a tester (TX for a DUT), 0 ~ 78, 0-39-78(default)
READ:RFTC:SM:PACK_TYPE?
Description
This command reads packet type.
CONF:RFTC:SM:PACK_TYPE <Value>
Description
This command writes packet type.
Value
packet type : DH3, DH5(default)
READ:RFTC:SM:HOP?
Description
This command reads hopping mode.
CONF:RFTC:SM:HOP <Value>
Description
This command writes hopping mode.
Value
hopping mode : ON, OFF(default)
READ:RFTC:SM:RX_LEV?
Description
This command reads power at the receiver input of the DUT in dBm.
CONF:RFTC:SM:RX_LEV <Value>
Description
This command writes RX power at the receiver input of the DUT in dBm.
Value
DUT RX Level : -327.68 ~ 20
READ:RFTC:SM:BYTES?
Description
This command reads minimum number of samples(returned payload bytes) to measure BER.
CONF:RFTC:SM:BYTES <Value>
Description
This command writes minimum number of samples(returned payload bytes) to measure BER.
Value
minimum number of samples : 0 ~ 2147000000, 200000(default)