Tescom TC-3000C - EDR Sensitivity(ES)

5.3 Reference Guide using RS-232C commands
137
channel : 0-39-78(default)
(ex) In case of setting channel 0 : CONF:RFTC:ESE:CH 0
In case of setting channel 0, 39, 78 : CONF:RFTC:ESE:CH 0-39-78
READ:RFTC:ESE:PACK_TYPE?
Description
This command reads packet type for EDR In-band Spurious Emission(TRM/CA/13/C) measurement.
CONF:RFTC:ESE:PACK_TYPE <Value>
Description
This command sets packet type for EDR In-band Spurious Emission(TRM/CA/13/C) measurement.
Value
Packet type : 2-LONGEST(default),3-LONGEST,2-DH1,3-DH1,2-DH3,3-DH3,2-DH5,3-DH5,2-EV3,3-EV3,2-
EV5,3-2V5
READ:RFTC:ESE:TEST_MODE?
Description
This command reads test mode for EDR In-band Spurious Emission(TRM/CA/13/C) measurement.
CONF:RFTC:ESE:TEST_MODE <값>
Description
This command sets test mode for EDR In-band Spurious Emission(TRM/CA/13/C) measurement.
Value
Test Mode : TRANSMITTER_TEST(default), LOOPBACK_TEST
READ:RFTC:ESE:SWP_NUM?
Description
This command reads number of sweep for EDR In-band Spurious Emission(TRM/CA/13/C) measurement.
CONF:RFTC:ESE:SWP_NUM <Value>
Description
This command sets number of sweep for EDR In-band Spurious Emission(TRM/CA/13/C) measurement.
Value
Number of sweeps : 1~65535, 10(default)
READ:RFTC:ESE:P_TX?
Description
This command reads adjacent channel power from EDR In-band Spurious Emission(TRM/CA/13/C)
measurement. Before reading this value use “READ:RFTC:ESE:P_TX?” Command, RF test case should be
executed to update this value by sending “EXEC:RFTC:ESE:RUN”.
5.3.23 EDR Sensitivity(ES)
EXEC:RFTC:ES:RUN
Description
This command executes EDR Sensitivity(RCV/CA/07/C) measurement.
EXEC:RFTC:ES:STOP
Description
This command stops execution of running EDR Sensitivity(RCV/CA/07/C) measurement. It is used to cancel
the running RF test case which is started by “EXE:RFTC:ES:RUN” command.