Tescom TC-3000C - General Purpose Communication Analyzer; Signal Generator; [Table 5] Pattern Example

3.11 General Purpose Communication Analyzer
81
3.11 General Purpose Communication Analyzer
3.11.1 Signal Generator
TC-3000C provides a general purpose RF source for ISM band receiver test.
Measurement can be accessed by pressing the Menu hard key. Press Menu 
Rotary Knob or  ,
  Select “SigGen” from the pop-up menu on the screen  ENT
Parameters
Range
Default
Frequency
2.4~2.5 GHz
2.45 GHz
Power
-80~0 dBm
0
Bit Pattern
0 ~ 0×FFFFFFFF
55555555
FM Deviation
0~1000 kHz
150
0 × 00000000
0 × FFFFFFFF
0 × 55555555
0 × F0F0F0F0
[Table 5] Pattern Example
Frequency: Set Carrier frequency.
Range: 2.4 ~ 2.5 GHz
Power: Set RF output level.
Range: -80 ~ 0 dBm
Bit Pattern : Set FSK modulation Pattern
Range: 0 ~ 0×FFFFFFFF
FM Deviation: Set FM deviation.
Range: 0 ~ 1000 kHz
Start/Stop: When this menu is pressed the
modulated signal will be transmitted. When the
menu is pressed again while the signal is
transmitting, the transmission will stop.