Tescom TC-3000C - Single Slot Sensitivity(SS)

5.3 Reference Guide using RS-232C commands
122
hopping mode : ON(default), OFF
READ:RFTC:CFD:TEST_MODE?
Description
This command reads test mode.
CONF:RFTC:CFD:TEST_MODE <Value>
Description
This command writes test mode.
Value
Test mode : LOOPBACK_TEST, TRANSMITTER_TEST(default), NULL_PKT_TEST
READ:RFTC:CFD:DRIFT_MAX?
Description
This command reads maximal frequency drift in hundreds Hz.
READ:RFTC:CFD:RATE_MAX?
Description
This command reads maximal drift rate in hundreds Hz per 50 us.
5.3.14 Single Slot Sensitivity(SS)
EXEC:RFTC:SS:RUN
Description
This command executes measurement of single slot sensitivity test case(RCV/CA/01/C).
EXEC:RFTC:SS:STOP
Description
This command stops execution of single slot sensitivity.
READ:RFTC:SS:CH?
Description
This command reads RX frequency of a tester(TX for a DUT).
CONF:RFTC:SS:CH <Value>
Description
This command writes RX frequency of a tester(TX for a DUT).
Value
channel : RX frequency of a tester (TX for a DUT), 0 ~ 78, 0-39-78(default)
READ:RFTC:SS:PACK_TYPE?
Description
This command reads packet type.
CONF:RFTC:SS:PACK_TYPE <Value>
Description
This command writes packet type.
Value
packet type : DH1(default), AUX1
READ:RFTC:SS:HOP?
Description