5.3 Reference Guide using RS-232C commands
109
Return Value
Link : ON, OFF
5.3.2 Access Command
EXEC:RESET
Description
This command sets “Standby” state of the tester’s Host controller and clears databases of discovered DUTs
and links (ACL and SCO) at both Host and Host controller.
EXEC:NEW_DUT
Description
This command reinitializes (creates) HCI transport layer to the DUT (if necessary) and resets the tester.
EXEC:STOP
Description
This command stops execution of running commands.
EXEC:PRESET
Description
This command is used to reset most of parameters of TC-3000C to default value.
EXEC:LOCAL
Description
This command is used to change remote mode to local mode.
EXEC:DISCOVERABLE
Description
This command is used to make TC-3000C a Bluetooth device in range that will respond to an inquiry/page
message.
READ:SERIAL_NUM?
Description
This command reads serial number of TC-3000C.
READ:GUI_VERSION?
Description
This command reads firmware version of TC-3000C.
READ:CONN_DUT_BD_ADDR?
Description
This command reads Bluetooth device address from DUT under connection state.
READ:CONN_DUT_NAME?
Description
This command reads Bluetooth device name from DUT under connection state.
EXEC:DISCOVER
Description
This command find Bluetooth device of circumference.
READ:DISCOVERED_BD_ADDR?
Description
To Next Page
Loading...
