Tescom TC-3000C - Page 108

5.3 Reference Guide using RS-232C commands
108
This command reads the packet type of DUT.
CONF:SYS:DUT:PACK_TYPE <Value>
Description
This command writes packet type of DUT.
Value
Packet_type : DH1(default), HV1, HV3, AUX1, DM3, DH3, DM5, DH5, EV3, EV4, EV5, 2-DH1, 3-DH1,
2-DH3, 3-DH3, 2-DH5, 3-DH5, 2-EV3, 3-EV3, 2-EM5, 3-EV5
READ:SYS:DUT:BIT_PATTERN?
Description
This command reads the bit pattern of DUT.
CONF:SYS:DUT:BIT_PATTERN <Value>
Description
This command writes bit pattern of DUT.
Value
Bit_pattern : 00000000, 11111111, 10101010(default), 11110000, PRBS9
READ:SYS:DUT:HOP?
Description
This command reads hopping mode of DUT.
CONF:SYS:DUT:HOP <Value>
Description
This command writes hopping mode of DUT.
Value
hopping mode : ON, OFF(default)
READ:SYS:DUT:TX_CH?
Description
This command reads TX channel of a tester. (RX for DUT)
CONF:SYS:DUT:TX_CH <Value>
Description
This command writes TX channel of a tester.
Value
Tx_ch : 0(default) ~ 78
READ:SYS:DUT:RX_CH?
Description
This command reads RX channel of a tester. (TX for DUT)
CONF:SYS:DUT:RX_CH <Value>
Description
This command writes RX channel of a tester.
Value
Tx_ch : 0(default) ~ 78
READ:SYS:DUT:Link?
Description
This command checks whether a RF link with a DUT exists.