Tescom TC-3000C - Operation Procedure (Bluetooth Conformance Test)

3.8 Operation Procedure (Bluetooth Conformance Test)
69
3.8 Operation Procedure (Bluetooth Conformance Test)
This chapter describes the operation procedure of Bluetooth Conformance Test. You can test
BT device with only a single keystroke. When the Start key is pressed, the TC-3000C
instates a link, activates Test Mode, performs the measurements and reports the results with
batch processing. Under the Test Mode (Transmitter or Loop back), tests are made exactly
as defined in the Bluetooth Test Specification. The tables below represent the supported test
cases.
Category
TC identifier
Description
Test Mode
RF
(Transmitter)
TRM/CA/01/C
Output power
TX, Loopback, Null packet
TRM/CA/02/C
Power Density
TX, Loopback, Null packet
TRM/CA/03/C
Power Control
TX, Loopback, Null packet
TRM/CA/04/C
TX Output Spectrum – Frequency range
TX, Loopback, Null packet
TRM/CA/05/C
TX Output Spectrum – 20dB Bandwidth
TX, Loopback, Null packet
TRM/CA/06/C
TX Output Spectrum – Adjacent channel power
TX, Loopback
TRM/CA/07/C
Modulation Characteristics
TX, Loopback
TRM/CA/08/C
Initial Carrier Frequency Tolerance
TX, Loopback, Null packet
TRM/CA/09/C
Carrier Frequency Drift
TX, Loopback
RF
(Receiver)
RCV/CA/01/C
Sensitivity – Single slot packets
Loopback
RCV/CA/02/C
Sensitivity – Multi-slot packets
Loopback
RCV/CA/06/C
Maximum Input Level
Loopback
BER + FER
Quick (OP+MOD+ICFT+CFD)
BT LE
TRM-LE/CA/01/C
Output power
TRM-LE/CA/03/C
In-Band Emissions
TRM-LE/CA/05/C
Modulation Characteristics
TRM-LE/CA/06/C
Carrier Frequency Offset and Drift
RCV-LE/CA/01/C
Receiver Sensitivity
RCV-LE/CA/06/C
Maximum Input Signal Level
RCV-LE/CA/07/C
PER Report integrity
Quick (OP+MOD+CFOD)
EDR
(Enhanced
Data Rate)
TRM/CA/10/C
EDR Relative Transmit Power
TX, Loopback
TRM/CA/11/C
EDR Carrier Frequency Stability & Modulation
Accuracy
TX, Loopback
TRM/CA/12/C
EDR Differential Phase Encoding
TX
TRM/CA/13/C
EDR In-band Spurious Emissions
TX, Loopback