Tescom TC-3000C - Enhances Power Control(EPC)

5.3 Reference Guide using RS-232C commands
113
Value
packet type : LONGEST, DM1, DH1(default), AUX1, DM3, DH3, DM5, DH5
READ:RFTC:PC:PACK_NUM?
Description
This command reads number of packets.
CONF:RFTC:PC:PACK_NUM <Value>
Description
This command wrties number of packets.
Value
number of packet : 1(default), 0 ~ 65535
READ:RFTC:PC:TEST_MODE?
Description
This command reads test mode.
CONF:RFTC:PC:TEST_MODE <Value>
Description
This command writes test mode.
Value
Test mode : LOOPBACK_TEST, TRANSMITTER_TEST(default), NULL_PKT_TEST
READ:RFTC:PC:P_MIN?
Description
This command reads the minimum power in 0.01dBm.
READ:RFTC:PC:P_MAX?
Description
This command reads the maximum power in 0.01 dBm.
READ:RFTC:PC:P_ST_MIN?
Description
This command reads the minimum power step in 0.01 dBm.
READ:RFTC:PC:P_ST_MAX?
Description
This command reads the maximum power step in 0.01 dBm.
5.3.7 Enhances Power Control(EPC)
EXEC:RFTC:EPC:RUN
Description
This can be used for Enhanced power control test case(TRM/CA/14/C).
EXEC:RFTC:EPC:STOP
Description
This command stops execution of Enhanced power control measurement.
READ:RFTC:EPC:CH?
Description
This command reads RX frequency of a tester(TX for a DUT).