Tescom TC-3000C - Settings for Ethernet(Host) Remote Control Using DLL; Settings for USB(Host Controller) Remote Control Using DLL

5.2 Getting Started
99
5.2.1 Settings for Ethernet(Host) remote control using DLL
1. Setting up Netwok Parameters: Press Menu  Select “Configuration” from the pop-up
menu on the screen  M5 (Network)  Setting up Network Parameters
2. Enable Remote Control: Press F7 on the above screen to set Remote Ctrl to
“Checked”.
3. Reboot TC-3000C.
4. If you have the following screen, the setting has been done successfully.
5. Execute “PING” command on you PC so as to see if TC-3000C is operating and also to
see if network connections are intact.
6. Call the following functions in your application to make Ethernet remote control program
using DLL.
(1) write_tester_hci_tl(16); // TCP/IP : 16
(2) write_local_ip(“10.52.147.71”); // “Local IP” of user PC is “Remote IP” of TC-3000C.
(3) wirte_remote_ip(“10.52.147.70”); // “Remote IP” of user PC is “Local IP” of TC-3000C
5.2.2 Settings for USB(Host Controller) remote control using DLL
1. Copy following files to your system directory.
 Files required : tc_terter.sys, tc_tester.inf
 System Directory : C:/WINDOWS/system32(Windows XP)
2. Connect USB port of TC-3000C Host Controller with USB port of your PC, and then use
the “Found New Hardware Wizard”. Even If our driver has not passed Windows Logo
testing, Ignore it and push the “ContinueAnyway” button. Our driver will be installed
successfully.
3. Call the following functions in your application to make USB remote control program
using DLL.
NOTE
Make sure the Local IP and Remote IP is correct on the above screen.
LAN Remote Contorl Mode
Version : 1.16 04-09-22
Boot time : 08:28:38 10/29/2004
Local_IP : 10.52.147.70
Remote_IP : 10.52.147.71
i
Quit
Quit
With Switch to Normal Mode
Local IP of TC-3000C
Local IP of user PC