5.3 Reference Guide using RS-232C commands
132
EXEC:RFTC:ETP:RUN" command should be exected to update measurement value.
READ:RFTC:ETP:PMIN_FSK?
Description
This command reads GFSK minimum output power of EDR Relative Transmit Power(TRM/CA/10/C)
measurement. Before reading this value by " READ:RFTC:ETP:PMIN_FSK?" command, "
EXEC:RFTC:ETP:RUN" command should be exected to update measurement value.
READ:RFTC:ETP:PMIN_PSK?
Description
This command reads DPSK minimum output power of EDR Relative Transmit Power(TRM/CA/10/C)
measurement. Before reading this value by " READ:RFTC:ETP:PMIN_PSK?" command, "
EXEC:RFTC:ETP:RUN" command should be exected to update measurement value.
5.3.20
EDR Carrier Frequency Stability & Modulation Accuracy(EFSMA)
EXEC:RFTC:EFSMA:RUN
Description
This command executes measurement of EDR Carrier Frequency Stability & Modulation
Accuracy(TRM/CA/11/C) measurement.
EXEC:RFTC:EFSMA:STOP
Description
This command stops execution of EDR Carrier Frequency Stability & Modulation Accuracy(TRM/CA/11/C)
measurement. It is used to cancel the running RF test case which is started by “EXE:RFTC:EFSMA:RUN”
command.
READ:RFTC:EFSMA:CH?
Description
This command reads channel value for EDR Carrier Frequency Stability & Modulation
Accuracy(TRM/CA/11/C) measurement.
CONF:RFTC:EFSMA:CH <Value>
Description
This command checks channel for EDR Carrier Frequency Stability & Modulation Accuracy(TRM/CA/11/C)
measurement.
Value
channel : 0-39-78(default)
(ex) In case of setting channel 0 : CONF:RFTC:EFSMA:CH 0
In case of setting channel 0, 39, 78 : CONF:RFTC:EFSMA:CH 0-39-78
READ:RFTC:EFSMA:PACK_TYPE?
Description
This command reads packet type for EDR Carrier Frequency Stability & Modulation Accuracy(TRM/CA/11/C)
measurement.
CONF:RFTC:EFSMA:PACK_TYPE <Value>
Description
This command sets packet type for EDR Carrier Frequency Stability & Modulation Accuracy(TRM/11/C)
measurement
Value
Packet type : 2-LONGEST(default),3-LONGEST,2-DH1,3-DH1,2-DH3,3-DH3,2-DH5,3-DH5,2-EV3,3-EV3,2-
EV5,3-2V5
To Next Page
Loading...