Tescom TC-3000C - Page 131

5.3 Reference Guide using RS-232C commands
131
Packet type : 2-LONGEST(default),3-LONGEST,2-DH1,3-DH1,2-DH3,3-DH3,2-DH5,3-DH5,2-EV3,3-EV3,2-
EV5,3-2V5
READ:RFTC:ETP:PACK_NUM?
Description
This command reads number of packet for EDR Relative Transmit Power(TRM/CA/10/C) measurement.
CONF:RFTC:ETP:PACK_NUM <Value>
Description
This command sets number of packet for EDR Relative Transmit Power(TRM/CA/10/C) measurement.
Value
Number of packets : 0~65535, 1(default)
READ:RFTC:ETP:TEST_MODE?
Description
This command reads test mode for EDR Relative Transmit Power(TRM/CA/10/C) measurement.
CONF:RFTC:ETP:TEST_MODE <Value>
Description
This command sets test mode for EDR Relative Transmit Power(TRM/CA/10/C) measurement.
Value
Test Mode : TRANSMITTER_TEST(default), LOOPBACK_TEST
READ:RFTC:ETP:HOP?
Description
This command reads hopping mode for EDR Relative Transmit Power(TRM/CA/10/C) measurement.
CONF:RFTC:ETP:HOP <Value>
Description
This command sets hopping mode for EDR Relative Transmit Power(TRM/CA/10/C) measurement.
Value
Hopping Mode : OFF(default), ON
READ:RFTC:ETP:PAV_FSK?
Description
This command reads GFSK average output power of EDR Relative Transmit Power(TRM/CA/10/C)
measurement. Before reading this value by " READ:RFTC:ETP:PAV_FSK?" command, "
EXEC:RFTC:ETP:RUN " command should be exected to update measurement value.
READ:RFTC:ETP:PAV_PSK?
Description
This command reads DPSK average output power of EDR Relative Transmit Power(TRM/CA/10/C)
measurement. Before reading this value by " READ:RFTC:ETP:PAV_PSK? " command, "
EXEC:RFTC:ETP:RUN" command should be exected to update measurement value.
READ:RFTC:ETP:PMAX_FSK?
Description
This command reads GFSK maximum output power of EDR Relative Transmit Power(TRM/CA/10/C)
measurement. Before reading this value by " READ:RFTC:ETP:PMAX_FSK?" command, "
EXEC:RFTC:ETP:RUN" command should be exected to update measurement value.
READ:RFTC:ETP:PMAX_PSK?
Description
This command reads DPSK maximum output power of EDR Relative Transmit Power(TRM/CA/10/C)
measurement. Before reading this value by " READ:RFTC:ETP:PMAX_PSK?" command, "