5.3 Reference Guide using RS-232C commands
120
READ:RFTC:ICFT:CH?
Description
This command reads RX frequency of a tester(TX for a DUT).
CONF:RFTC:ICFT:CH <Value>
Description
This command writes RX frequency of a tester(TX for a DUT).
Value
channel : RX frequency of a tester (TX for a DUT), 0 ~ 78, 0-39-78(default)
READ:RFTC:ICFT:PACK_NUM?
Description
This command reads number of packets.
CONF:RFTC:ICFT:PACK_NUM <Value>
Description
This command writes number of packets.
Value
number of packet : 10(default), 0 ~ 65535
READ:RFTC:ICFT:HOP?
Description
This command reads hopping mode.
CONF:RFTC:ICFT:HOP <Value>
Description
This command writes hopping mode.
Value
hopping mode : ON(default), OFF
READ:RFTC:ICFT:TEST_MODE?
Description
This command reads test mode.
CONF:RFTC:ICFT:TEST_MODE <Value>
Description
This command writes test mode.
Value
Test mode : LOOPBACK_TEST, TRANSMITTER_TEST(default), NULL_PKT_TEST
READ:RFTC:ICFT:DF0_MIN?
Description
This command reads minimal deviation of carrier frequencies from (2402+frequency) MHz in hundreds Hz.
READ:RFTC:ICFT:DF0_MAX?
Description
This command reads maximal deviation of carrier frequencies from (2402+frequency) MHz in hundreds Hz.
READ:RFTC:ICFT:DF0_AVG?
Description
To Next Page
Loading...
