Tescom TC-3000C - Page 102

5.3 Reference Guide using RS-232C commands
102
This command set the timeout of RFCOMM commands execution in milliseconds.
Value
RFComm Timeout : 1 ~ 65535, 5000(default)
READ:SYS:TESTER:SDP_TO?
Description
This command reads the timeout of SDP commands execution in milliseconds.
CONF:SYS:TESTER:SDP_TO <Value>
Description
This command set the timeout of SDP commands execution in milliseconds.
Value
SDP Timeout : 1 ~ 65535, 5000(default)
READ:SYS:TESTER:PROFILE_TO?
Description
This command reads the timeout of PROFILE commands execution in milliseconds.
CONF:SYS:TESTER:PROFILE_TO <Value>
Description
This command set the timeout of PROFILE commands execution in milliseconds.
Value
Profile Timeout : 1 ~ 65535, 5000(default)
READ:SYS:TESTER:FRIENDLY_NAME?
Description
This command reads the Friendly Name of the tester.
CONF:SYS:TESTER:FRIENDLY_NAME <Value>
Description
This command set the Friendly Name of the tester.
Value
Friendly Name : 54.43.2D.33.30.30.30.42
(ex) In case of “TC-3000C”, input “54.43.2D.33.30.30.30.42”
READ:SYS:TESTER:NUM_RESP?
Description
This command reads maximum number of response during the inquiry of a tester
CONF:SYS:TESTER:NUM_RESP <Value>
Description
This command sets maximum number of responses from the Inquiry of a tester.
For example, if this value is set 1, TC-3000C will find only one DUT and finish immediately the inquiry
procedure.
Value
Inquiry Responses : 0 ~ 16, 1(default)
READ:SYS:TESTER:PINCODE?
Description
This command reads PIN code(passkey) of the tester.
CONF:SYS:TESTER:PINCODE <Value>
Description
This command writes PIN code(passkey) of the tester. The PIN is used to authenticate two Bluetooth