5.3 Reference Guide using RS-232C commands
144
READ:AUDIO:VGM?
Description
This command reads mike gain during connection procedure with Profiles.
CONF:AUDIO:VGM <Value>
Description
This command sets gain of a mike gain during connection procedure with Profiles.
Value
VGM : 0~15, 15(default)
EXEC:AUDIO:TEST:RUN
Description
This command executes measurement of the parameter of RX audio signal.
READ:AUDIO:TEST:FREQ?
Description
This command reads frequency of the audio signal's power density maximum.
READ:AUDIO:TEST:F_POW?
Description
This command reads peak value of the power in audio spectrum characteristic.
READ:AUDIO:TEST:RMS?
Description
This command reads RMS value of the audio signal.
READ:AUDIO:TEST:SINAD?
Description
This command reads SINAD value of the audio signal.
READ:AUDIO:TEST:DIST?
Description
This command reads distortion of the audio signal.
EXEC:AUDIO:SCOC
Description
This command executes SCO link with a DUT.
EXEC:AUDIO:PAIRABLE
Description
This command executes TC-3000C as slave mode. This differently works depending on profile type.
EXEC:AUDIO:TALK
Description
This command creates ACL(or “ACL and SCO”) link under Audio Gateway Profile. Accordingly user must
send “CONF:AUDIO:PROFILE_TYPE AUDIOGATEWAY” command before this.
EXEC:AUDIO:STOP
Description
This command stops the execution of “EXEC:AUDIO:TALK” command.
READ:AUDIO:PACK_TYPE?
Description
This command reads the packet type the tester shall use for the SCO connection.
To Next Page
Loading...
