Tescom TC-3000C - Page 145

5.3 Reference Guide using RS-232C commands
145
CONF:AUDIO:PACK_TYPE <Value>
Description
This command writes the packet type the tester shall use for the SCO connection.
Value
packet type : HV1, HV2, HV3(default)
READ:AUDIO:AIR_CODING?
Description
This command reads air coding format for SCO links.
CONF:AUDIO:AIR_CODING <Value>
Description
This command writes air coding format for SCO links.
Value
air coding format : CVSD(default), U-LAW, A-LAW
EXEC:AUDIO:LB_START
Description
This command executes entering the SCO loopback mode to send all SCO data back to the DUT.
EXEC:AUDIO:LB_STOP
Description
This command stops the SCO loopback mode to send all SCO data back to the DUT.
READ:AUDIO:LB_DELAY?
Description
This command reads the delay of SCO loopback in milliseconds.
CONF:AUDIO:LB_DELAY <Value>
Description
This command writes the delay of SCO loopback in milliseconds.
Value
delay time : 0, 2, 5
READ:AUDIO:TEST_OP_ICFT:AUDIO_IN?
Description
This command reads required filter value.
CONF:AUDIO:TEST_OP_ICFT:AUDIO_IN <Value>
Description
This command writes proper filter value in accordance with received audio signal.
Value
filter : 400, 1000(default)
EXEC:AUDIO:TEST_OP_ICFT:RUN
Description
This command executes measurement in the audio spectrum.
READ:AUDIO:TEST_OP_ICFT:FREQ?
Description
This command reads frequency of the audio signal's power density maximum.