5.3 Reference Guide using RS-232C commands
146
READ:AUDIO:TEST_OP_ICFT:F_POW?
Description
This command reads peak value of the power in the audio spectrum.
READ:AUDIO:TEST_OP_ICFT:RMS?
Description
This command reads RMS value of the power in the audio spectrum.
READ:AUDIO:TEST_OP_ICFT:SINAD?
Description
This command reads SINAD value in the audio spectrum.
READ:AUDIO:TEST_OP_ICFT:DIST?
Description
This command reads distortion in the audio spectrum.
READ:AUDIO:TEST_OP_ICFT:CH?
Description
This command reads RX frequency of a tester(TX for a DUT).
CONF:AUDIO:TEST_OP_ICFT:CH <Value>
Description
This command writes RX frequency of a tester(TX for a DUT).
Value
Tchannel : RX frequency of a tester(TX for a DUT), 0~78, 0-39-78(default)
READ:AUDIO:TEST_OP_ICFT:P_AVG?
Description
This command reads the average power.
READ:AUDIO:TEST_OP_ICFT:P_MIN?
Description
This command reads minimum power.
READ:AUDIO:TEST_OP_ICFT:P_MAX?
Description
This command writes maximum power.
READ:AUDIO:TEST_OP_ICFT:DF0_MIN?
Description
This command reads minimal deviation of carrier frequencies from (2402+frequency) MHz in hundreds Hz.
READ:AUDIO:TEST_OP_ICFT:DF0_MAX?
Description
This command reads minimal deviation of carrier frequencies from (2402+frequency) MHz in hundreds Hz.
READ:AUDIO:TEST_OP_ICFT:DF0_AVG?
Description
This command reads average deviation of carrier frequencies from (2402+frequency) MHz in hundreds Hz.
READ:AUDIO:TEST_OP_ICFT:DF2_AVG?
Description
This command reads average of all maximum frequency deviations from the average frequency for the
10101010 pattern in Hz divided by 100.
To Next Page
Loading...
