Tescom TC-3000C - Page 166

5.7 Reference Guide for using DLL
166
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be
an error code.
Parameter
connection_handle // the connection handle of the SCO link to send tone signal
upgrade_tester_licence
Description
This function upgrades the tester licence.
Syntax
unsigned long upgrade_tester_licence(char *file_name );
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be
an error code.
Parameter
file_name // name of the file which stores the tester licence
read_hci_to
Description
This function reads the timeout of HCI commands execution in miliseconds
Syntax
unsigned long read_hci_to (unsigned short *hci_timeout);
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be
an error code.
Parameter
hci_timeout // Range : 1 ~ 65535
write_hci_to
Description
This function writes the timeout of HCI command execution in milliseconds.
Syntax
unsigned long write_hci_to(unsigned short hci_timeout);
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be
an error code.
Parameter
hci_timeout // Range : 1 ~ 65535, Default : 2000(2 s).
read_tester_agc
Description
This function reads the RX AGC(Automatic Gain Control) value of a tester.
Syntax
unsigned long read_tester_agc(unsigned char *agc);
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be