5.7 Reference Guide for using DLL
170
page_to // Range : 1 ~ 65535, Time Range: 0.625 ms ~ 40.9 s.
write_tester_page_to
Description
This function writes the page timeout of a tester. The page timeout defines the maximum time the local Link
Manager will wait for a baseband page response from the remote device at a locally initiated connection
attempt. If this time expires and the remote device has not responded to the page at baseband level, the
connection attempt will be considered to have failed.
Syntax
unsigned long write_tester_page_to(unsigned short page_to);
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be
an error code.
Parameter
page_to // Range : 1 ~ 65535, Time Range: 0.625 ms ~ 40.9 s.
read_tester_port_conf
Description
This function reads the external port configuration of a tester.
Syntax
unsigned long read_tester_port_conf (unsigned char port_num, unsigned char *port_conf);
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be
an error code.
Parameter
port_num // 0:OUT1, 1:OUT2, 3:IN1, 4:IN2
port_conf // For OUT1/OUT2, 0:I_RX, 1:Q_RX, 2:I_TX, 3:Q_TX, 4:RX_BITS, 5:TX_BITS, 6:MOD,
7:DEMOD.
// For In1/In2, 0:OFF1_OFF2,3:RX_IQ_IN, 4:RX_EXT_BIT_1,
// 8:RX_EXT_BIT_2, 48:TX_IQ_IN, 64:TX_EXT_BIT_1,128:TX_EXT_BIT_2
write_tester_port_conf
Description
This function writes the external port configuration of a tester.
Syntax
unsigned long write_tester_port_conf(unsigned char port_num, unsigned char port_conf);
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be
an error code.
Parameter
port_num // 0:OUT1, 1:OUT2, 3:IN1, 4:IN2
port_conf // For OUT1/OUT2, 0:I_RX,1:Q_RX, 2:I_TX, 3:Q_TX, 4:RX_BITS, 5:TX_BITS, 6:MOD, 7:DEMOD.
// For In1/In2, 0:OFF1_OFF2, 3:RX_IQ_IN, 4:RX_EXT_BIT_1,
// 8:RX_EXT_BIT_2, 48:TX_IQ_IN, 64:TX_EXT_BIT_1, 128:TX_EXT_BIT_2
read_tester_rx_gain
Description
This function reads the gain of RX amplifier of a tester.
Syntax
To Next Page
Loading...
