Tescom TC-3000C - Page 182

5.7 Reference Guide for using DLL
182
Parameter
inq_sup // 0:Not support, 1:support
write_dut_inq_sup
Description
This function writes the flag whether the DUT supports inquiry. If parameter of this function is 0(the DUT does
not support inquiry), use the function write_dut_bdaddr.
Syntax
unsigned long write_dut_inq_sup(unsigned char inq_sup);
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be
an error code.
Parameter
inq_sup // 0:Not support, 1:support(default)
read_dut_inquiry_scan_interval
Description
This function reads the inquiry scan interval of the DUT measured in number of Baseband slots. Refer to
write_dut_inquiry_scan_interval for more details.
Syntax
unsigned long read_dut_inquiry_scan_interval(unsigned short *inquiry_scan_interval);
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be
an error code.
Parameter
inquiry_scan_interval // Range : 18 ~ 4096.
write_dut_inquiry_scan_interval
Description
This function writes the inquiry scan interval of the DUT measured in number of Baseband slots. The
inquiry_scan_interval configuration parameter defines the amount of time between consecutive inquiry scans.
This is defined as the time interval from when the Host Controller started its last inquiry scan until it begins
the next inquiry scan.
Syntax
unsigned long write_dut_inquiry_scan_interval(unsigned short inquiry_scan_interval);
Return Value
The return value of this function will be zero if the function is successful. Otherwise, the return value will be
an error code.
Parameter
inquiry_scan_interval // Range : 18 ~ 4096. Default : 2048.
read_dut_inquiry_scan_window
Description
This function reads the inquiry scan window of the DUT measured in nmber of Baseband slots. Refer
to write_dut_inquiry_scan_window for more details.
Syntax
unsigned long read_dut_inquiry_scan_window(unsigned short *inquiry_scan_window);
Return Value