7-20 4181383 First Edition
STEERING
7
Installation Notes
• Install the steering cylinder by reversing the order of
removal.
• Tighten castle nuts (6 and 9) to 80—110 lb-ft (108—
149 N·m). Adjust nuts as needed to align the slots
with the hole in the rod ends.
• Always install new cotter pins (5 and 10).
• Check hydraulic oil level. Add oil as needed.
• Start the machine and check for hydraulic leaks and
cylinder operation. Repair as necessary.
• Check steering toe-in adjustment. (See “Tie Rod
Adjustment” on page 7-4.)
To Next Page
Loading...
Need help?
General
