THOMSON Amethyst III - Page 31

Chapter 1 ’Overview’ — Chassis Description
Amethyst III DTV Smart Switch 31
User Manual
- Apply configuration Protected/Allowed
- Remove configuration Protected/Allowed
- Modify automation Protected/Allowed
- Delete closed alarms Protected/Allowed
- Manual switch Protected/Allowed
- Monitoring output selectionProtected/Allowed
- Reset monitoring counters Protected/Allowed
- Set maintenance mode Protected/Allowed
- Set FEC activation Protected/Allowed
 Relays management
- Relay 1 In configuration/Power
- Relay 2 In configuration/Error
- Relay 3 In configuration/Warning
As relay 4 is always defined in the configuration, it does not appear
on the front panel.
 Commands
- Reboot equipment No/Yes
- Delete equipment data No/Yes
- Delete closed alarms No/Yes
- Maintenance mode Off/On
- FEC activation Deactivated/Activated
To modify a parameter from the
F5 screen, press the C key to enter the
edition mode. Once you have made modifications, you can press
F1 to
save them or
F2 to cancel them.