THOMSON TG605s - Page 263

eth Commands
E-DOC-CTC-20080409-0002 v2.0
263
eth bridge unknownvlan ifdelete Delete bridge interface from unknown
'VLAN'.
see page 312
eth bridge unknownvlan iflist Display all interfaces of the unknown
'VLAN'.
see page 313
eth bridge vlan ifadd Add bridge interface to virtual LAN. see page 314
eth bridge vlan ifconfig Modify bridge interface from virtual
LAN.
see page 315
eth bridge vlan ifdelete Delete bridge interface from virtual
LAN.
see page 316
eth bridge vlan iflist Display all vitual LAN's. see page 317
eth bridge xtratag add Add an extra tag mapping entry. see page 318
eth bridge xtratag config Configure an extra tag mapping entry. see page 319
eth bridge xtratag delete Delete an extra tag mapping entry. see page 320
eth bridge xtratag flush Flush all extra tag mapping entries. see page 321
eth bridge xtratag list Display all extra tag mapping entries. see page 322
eth device ifconfig Configure ethernet interface. see page 323
eth device iflist Show status of ethernet interfaces. see page 324
eth filter operand add Add a filter operand. see page 325
eth filter operand config Set the operand to a certain type (will
reset content first).
see page 326
eth filter operand delete Delete a filter operand. see page 328
eth filter operand flush Remove all filter operands (this will
only delete the ones not in use: flush
see page 329
eth filter operand frameclassadd Add another frameclass in the set. see page 330
eth filter operand frameclassdelete Delete a frameclasse from the set. see page 331
eth filter operand ipprotoadd Add another ip protocol in the set. see page 332
eth filter operand ipprotodelete Delete a ip protocol from the set. see page 333
eth filter operand list Display the filter operands. see page 334
eth filter operand priorityadd Add another priority in the set. see page 335
eth filter operand prioritydelete Delete a ip priority from the set. see page 336
eth filter operand reset Reset an operand to its default initial
state (removes all content, set to
see page 337
eth filter operand vidadd Add another VID in the set. see page 338