THOMSON TG605s - Page 264

eth Commands
264
E-DOC-CTC-20080409-0002 v2.0
eth filter operand viddelete Delete a VID from the set. see page 339
eth filter template add Add a filter. see page 340
eth filter template config Config a filter. see page 341
eth filter template delete Delete a filter. see page 342
eth filter template flush Remove all filters. see page 343
eth filter template list Display the filters. see page 344
eth filter template ruleadd Connect an operand rule with a filter. see page 345
eth filter template ruledel Remove an operand rule from a filter. see page 346
eth filter template rulemodify Modify an operand rule from a filter. see page 347
eth filter template setpriority Action: enable/disable priority
derivation
see page 348
eth filter template setvid Action: enable/disable VID derivation see page 349
eth flush Flush all ETH interfaces. see page 350
eth ifadd Create a new ETH interface. see page 351
eth ifattach Attach an ETH interface. see page 352
eth ifconfig Modify an ETH interface. see page 353
eth ifdelete Delete an ETH interface. see page 354
eth ifdetach Detach an ETH interface. see page 355
eth iflist Display the ETH interfaces. see page 356
eth oam add Enable Ethernet OAM (E-OAM) on an
interface.
see page 357
eth oam config Modify global E-OAM settings. see page 358
eth oam configlist Display global E-OAM settings. see page 359
eth oam debug tracing Modify E-OAM tracing level. see page 360
eth oam delete Disable E-OAM on an interface. see page 361
eth oam list Display the E-OAM configuration of
an interface(s).
see page 362
eth oam loopback Enable/disable E-OAM remote
loopback for an interface.
see page 363
eth oam modify Modify E-OAM settings for an
interface.
see page 364
eth oam varreq Request a variable from the remote
side.
see page 365