THOMSON TG605s - Page 265

eth Commands
E-DOC-CTC-20080409-0002 v2.0
265
eth switch group flush To set all ports to the default settings
(all ports in group 0).
see page 366
eth switch group list List all configured groups. see page 367
eth switch group move Move a specified port to a specified
group.
see page 368
eth switch info Display switch capabilities see page 369
eth switch mirror capture Define the specified port to be the
Mirror Capture Port.
see page 370
eth switch mirror egress Enable or disable the specified port to
be a Transmitted Port Mirroring.
see page 371
eth switch mirror ingress Enable or disable the specified port to
be a Received Port Mirroring.
see page 372
eth switch qos config Configure common qos parameters. see page 373
eth switch qos ifconfig Configure per port qos parameters. see page 374
eth switch qos list Display qos configuration. see page 375
eth switch qos weights Configure the queue weights. see page 376
eth switch shaper config Configure common ingress shaper
parameters.
see page 377
eth switch shaper ifconfig Configure per port shaper
parameters.
see page 378
eth switch shaper iflist Display shaper configuration per port. see page 379
eth switch share add Add a port to be shared. see page 380
eth switch share delete Delete a shared port. see page 381
eth switch share list Display shared ports. see page 382
eth switch storm ifconfig Configure per port storm control
parameters.
see page 383
eth switch storm iflist Display storm control configuration
per port.
see page 384
eth vlan add Add a new virtual LAN. see page 385
eth vlan delete Delete a virtual LAN. see page 386
eth vlan flush Flush all virtual LAN's. see page 387
eth vlan list Display all virtual LAN's. see page 388