This property only has influence if the Encoder Movement property (see above) is set to
Dynamic. The Value Change Factor controls the amount of acceleration for dynamic
encoder movement.
The higher the value, the more the value change by encoder is accelerated.
Rule of thumb: The higher the value range of an object is, the higher the Value Change
Factor should be set.
Note: When simulating the project with the PClient simulation on the development PC, you
can test the effect of this property using the mouse wheel.
Default value: 1000
Possible values: 1 ... 32767
The property is only available if Set As Input for this object is enabled.
Input Character Attribute
This property is only available for the string field object. With the Input Character Attribute it
can be defined what characters are available when the user edits the value of the string
field.
It is possible to restrict the user input to certain characters defined in the selected Input
Character Attribute.
How an Input Character Attribute can be defined can be seen here .
If no Character Input Attribute is selected, the default ASCII character set will be available
as input characters for the user.
Default value: None
Possible values: Any Input Character Attribute defined in the project properties .
The property is only available if Set As Input for this object is enabled.
Inplace Editor
The Inplace Editor property is only available for String Field and Numeric Field objects.
With this property it can be chosen if the value of the object shall be changeable via
encoder or by using a virtual keyboard .
Default value: Encoder
Possible values: Encoder or Virtual Keyboard
The property is only available if Set As Input for this object is enabled.
Except for Preview Value, all value related properties are only available for objects
working with numeric values.
Absolute Max Value
As the name implies, the Absolute Max Value is the highest value that a user can set to an
object (Max Value is not, see below).
This property is available only for Arched Bargraph, Linear Bargraph, Meter and Numeric
Field objects.
Following rule applies: Absolute Max Value needs to be greater or equal to Max Value.
Default value: depends on object:
·
Arched Bargraph and Meter: 360
·
Linear Bargraph and Numeric Field: 100
Possible values: Anything greater or equal to Max Value but not more than 2147483647
(Absolute Min Value <= Min Value <= Max Value <= Absolute Max Value)
Color Above Maximum
To Next Page
Loading...