Note: The settings made for automatic variable change can be saved and loaded along
with other settings.
Note: Automatic value change generators are not available for string variables.
Value Range Generator
The value range generator changes the value of a variable within a given range. The
value is incremented or decremented within a configured period.
Use the following elements to configure the value range generator:
·
buttons
Pause or resume the generator (make sure that the rest of the configuration is
correct)
·
Start Value field
The starting value of the value range. This value needs to be less than End Value
·
End Value field
The end value of the value range. This needs to be greater than Start Value
·
Steps field
The current value of the variable will be incremented or decremented by this value.
Use positive values to increment and negative values to decrement.
·
Increment every field
This is the period after which every increment/decrement happens. The period is in
milliseconds and may not be below 10ms.
·
Repeat checkbox
When the range was completed, repeat the sequence. See also the two buttons
below that checkbox
·
button
When the end of the range is reached, the generator will start over with the start of
the range
·
button
When the end of the range is reached, the generator will run backwards to the start
of the range
The value switch generator is a simple generator that allows switching between two
values in a given period.
Use the following elements to configure the value switch generator:
·
buttons
Pause or resume the generator (make sure that the rest of the configuration is
correct)
·
Switch between fields
Enter the two values that shall be switched in these two fields
·
every field
Enter the period with which the values shall be switched. The period is in
milliseconds and may not be below 10ms.
To Next Page
Loading...