Topcon OPUS A6G2 - Page 629

629
OPUS Projektor Manual
Device Software Update
o Command ID
o Stream Len ID
o Stream ID
§ These for IDs will be used for CAN communication between HostUpdater
on PC and ClientUpdater on device.
§ It is important that these IDs are set properly, otherwise the connection or
transfer can not be established.
§ Each ID has to be in the valid range and must be unique.
NOTE (DANGER):
Please make sure that the CAN IDs which will be used for the CAN Transfer are
not used in the project and are not used from any other entity on the CAN
bus.
Device CAN Settings Page
These settings will be transmitted to the device in this transfer session. The
transmitted settings are available after the update has successfully finished.
Legend:
(1) With the Tabs you can choose between PC and Device CAN Settings.
(2) Show communication parameters (expert settings) shows the communication
parameters (3).