Alternatively, if you started the update from the Plugins Dialog, you will see a confirmation
dialog that asks you to restart the program. Cancel stops the update process. Select
Restart Now and then click Finish to install the update. Select Restart Later to continue
working and restart later. The bubble shown above will pop up in the status bar in the
bottom. Click the bubble to restart the program. You can also close the Projektor Tool
manually and at the next start, the update will be finished.
You will first see a screen with the update progress and information what is installed.
Afterwards the OPUS Projektor will start again and the update is finished.
Please note that it might take a while until the splash screen pops up.
After the program has opened, check the release notes in the Start Page for information
about the update.
The following modules can be part of updates:
Branding - This module contains some visual elements and formatting.
Camera ISO17215 - This module contains the Ethernet camera tool.
CANFreestyle - This module contains CANFreestyle CAN protocol functionality.
CANOpen - This module contains CANOpen CAN protocol functionality.
CAN IO - This module contains the DBC import functionality.
Converter - This module contains the project conversion functionality.
CORE - This module contains the core functionalities of the program.
Data Storage - This module contains functionalities for the project storage.
Encoding Support - This module contains functionality for UTF8 support.
Java Runtime Environment - Java runtime to run the program.
J1939 - This module contains J1939 CAN protocol functionality.
Module Updates - This module doesn't contain specific functionalities, it is a master
module for the update process .
Object Themes - This module contains the object theme functionality.
To Next Page
Loading...