e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 102
[ED14] Rear alignment plate home position error
[ED15] Paddle home position error
[ED16] Buffer tray home position error
Classification Error item
Finisher jam (Finisher section) The rear alignment plate is not at the home position. [MJ-
1103/1104]
Check item Measures
Rear alignment plate • Move the rear alignment plate. If there is any mechanical
problem, fix its mechanism.
Rear alignment plate home position
sensor (S7)
• Sensor check
• Connector check
• Harness check
Rear alignment motor (M9) • Motor check
• Connector check
• Harness check
Finisher controller board • Connector check
• Board check
Replace parts Remarks
Rear alignment plate home position
sensor (S7)
Rear alignment motor (M10)
Finisher controller board
Classification Error item
Finisher jam (Finisher section) The paddle is not at the home position. [MJ-1103/1104]
Check item Measures
Paddle • Rotate the paddle. If there is any mechanical problem, fix
its mechanism.
Paddle home position sensor (S3) • Sensor check
• Connector check
• Harness check
Paddle motor (M8) • Motor check
• Connector check
• Harness check
Finisher controller board • Connector check
• Board check
Replace parts Remarks
Paddle home position sensor (S3)
Paddle motor (M8)
Finisher controller board
Classification Error item
Finisher jam (Finisher section) The buffer tray is not at the home position. [MJ-1103/1104]
To Next Page
Loading...
