8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 103
[EF10] Selecting paper not supported by Saddle Stitch Finisher
[EF11] Saddle Stitch Finisher stapling error (front)
Check item Measures
Buffer tray guide • Open and close the buffer tray guide. If there is any
mechanical problem, fix its mechanism.
Buffer tray home position sensor (S5) • Sensor check
• Connector check
• Harness check
Buffer tray guide motor (M3) • Motor check
• Connector check
• Harness check
Finisher controller board • Connector check
• Board check
Replace parts Remarks
Buffer tray home position sensor (S5)
Buffer tray guide motor (M3)
Finisher controller board
Classification Error item
Finisher jam (Finisher section) In the Saddle Stitch Finisher, selection is made of an
unsupported paper size and type and an excess number of
pages for stapling.
Check item Measures
Setting In the Saddle Stitch Finisher, selection is made of an
unsupported paper size and type and an excess number of
pages for stapling.
Buffer tray home position sensor (S5) • Sensor check
• Connector check
• Harness check
Buffer tray guide motor (M3) • Motor check
• Connector check
• Harness check
Saddle controller board • Connector check
• Board check
Replace parts Remarks
Buffer tray home position sensor (S5)
Buffer tray guide motor (M3)
Saddle controller board
Classification Error item
Finisher jam (Saddle section)
To Next Page
Loading...
