e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 156
[CE00] Communication error between finisher and punch unit
[CF10] Communication module SRAM reading failure
Finisher control PC board
Classification Error item
Finisher related service call Communication error between finisher controller PC board
and punch controller PC board.
[MJ-1103/1104 (when MJ-6102 is installed)]
Check item Measures
Hole punch control PC board (HP) • Connector check
• Board check
Finisher control PC board (FIN) • Connector check
• Board check
Replace parts Remarks
Hole punch control PC board
Finisher control PC board
Classification Error item
Finisher related service call
Check item Measures
Equipment • Is the error recovered when the power of the equipment is
turned OFF and then back ON?
Setting • Check if the MJ-1103/1104 is set as the specified finisher
on the equipment. (08-4548=”1”)
Finisher control PC board (FIN) • Connector check
• Board check
Hole punch control PC board (HP) • Connector check (when MJ-6102 is installed)
• Board check
Replace parts Remarks
Finisher control PC board
Hole punch control PC board (when MJ-6102 is installed)
Replace parts Remarks
To Next Page
Loading...
