Registering User Groups and Templates 243
7
Press the [NAME1] button and the [NAME2] button, and then enter
the template name.
y [NAME 1] is displayed in the upper side and [NAME 2] is displayed in the lower side
of the template button. Enter [NAME 1] and/or [NAME 2]. When both are entered,
[NAME 1] is displayed in the upper side and [NAME 2] is displayed in the lower side
of the button.
y When the [NAME 1] or [NAME 2] button is pressed, the letter entry menu ( P. 4 1 ) i s
displayed. Up to 11 letters can be entered.
y The following symbols cannot be used for [NAME 1] and [NAME 2].
["], [=], [|], [*], [<], [>], [?], [+], [[], []], [;], [:], [/], [\], [,], [.]
8
Press the [USER NAME] button, and then enter the user name of
the template as required.
y When the [USER NAME] button is pressed, the letter entry menu ( P. 4 1 ) i s d i s -
played. Up to 30 letters can be entered.
To set the password, proceed to step 9. If not, skip to step 11.
To Next Page
Loading...
