2 HOW TO MAKE COPIES
88 Bypass Copying
Bypass copying on non-standard size paper
Non-standard size paper should be within the following ranges: A (Length): 3.9" to 11.7", B
(Width): 5.8" to 17"
y Rear side of the side guides of the bypass tray has an indicator for paper height. The
height of the sheets must not exceed this indicator.
y When you use more than one sheet, fan the sheets well before setting them on the
tray.
y Do not push the sheets into the entrance of the bypass feeder; it may cause a paper
jam.
y When the paper size is larger, draw out the three-stage paper holder. Raise B when
you use LD or a larger size of paper.
2
Place the original on the original glass.
1
Place some sheets of paper
with their copy side down on
the bypass tray. Align the side
guides to the paper length
while holding A.
The message “Ready for bypass
feeding” appears.
A
B
A
B
To Next Page
Loading...
Need help?
General
