3 SETTING OF BASIC COPY MODES
122 Selecting Finishing Modes
Hole punch mode (optional)
When the Hole Punch Unit (optional) is installed to the finisher (optional), you can punch holes in
the copies.
y The available copy paper sizes for this mode are LD, LG, LT, LT-R and COMP.
y The paper weight applicable for this mode is 17 lb. Bond to 140 lb. Index.
Special paper such as OHP films or sticker label cannot be used for hole punching.
1
Place paper in the drawer(s).
When using this mode in bypass copying, specify the paper size in advance. ( P.81
“Bypass Copying”)
2
Place the original(s).
3
Press the finisher button on the basic menu.
4
Press the [HOLE PUNCH] button.
Set other copy modes as required.
5
Press the [START] button.
To Next Page
Loading...
Need help?
General
