EVM Reports and Printing
EVM and Logging Settings
EVM Series User Manual
5. To set the auto-run, click on or save and send to the EVM (for more details see
“Saving and sending configurations”.
Figure 6-11: EVM Auto-Run with Date setting
Day of Week and Auto-Run Setting
To enable Date mode, follow the steps below.
1. Click on the Auto-Run tab (see ❶) from the EVM’s Instrument Communications panel.
2. Click in the
Enabled checkbox and click in the Day of Week field (see ❷).
3. To select a day or days click in the appropriate day boxes.
4. To set the Start Time and Duration, either click on the
or type in numeric value (see ❸).
5. To enable Day of Week 2, repeat steps 3–4.
6. To set the auto-run, click on or save and send to the EVM (for more details see
“Saving and sending configurations”.
Figure 6-12: EVM Auto-Run with Day of Week setting
To Next Page
Loading...
