TSI Quest EVM-7 User Manual

Setting up the Environmental Monitor
Setting up Parameters via the Keypad
EVM Series User Manual
24
 Set logging intervals, logging attributes, and view run time
1. From the start menu, press ▲/▼ Arrows to select Setup and press Enter . Select Logging
and press Enter
.
2. To change Logging Interval or Averaging follow below:
 Press ▲/▼ Arrows to select Logging interval or Averaging.
 Press Enter to move to the changeable field, and then press ▲/▼ Arrows.
 Press Enter to return to the 1
st
column and save your settings.
3. To enable/disable logging, follow below:
 Select a measurement by pressing ▲/▼ Arrows.
 Once selected, press Enter (this will move your cursor to the “On/Off” field.)
 Press ▲/▼ Arrows to toggle and select On or Off.
 Press Enter again to return to the measurement.
 Repeat step 3 until all logging parameters are enabled/disabled.
Logging time/averaging time
Logging attributes/measurements
Run Time
When selected, the estimated run time screen
displays the total remaining time.
Figure 3-5: Logging screen

TSI Quest EVM-7 Specifications

General

Brand	TSI Quest
Model	EVM-7
Category	Measuring Instruments
Language	English