Setting up Parameters via the Keypad
Lock/Secure Run and/or Setup
EVM Series User Manual
Setting lock setup or run
1. From the Start screen, select and open the Setup screen.
2. Press the Lock soft key.
Lock
Opens to the Lock screen.
Figure 3-20: Lock Soft key
3. In the Lock/Security Modes screen, Run and Setup are “disabled” as the default setting.
4. To enable either one, first select Run or Setup fields (by using Up/Down Arrows).
5. Press Enter
and the first field will be shaded/selected, and then press ▲/▼ Arrows to
change the numeric value.
Adding a numeric password
Press Up/Down arrows to enter a number.
Press Left/Right arrow keys to move to the next
field.
Repeat as necessary.
Figure 3-21: Setting lock/secure
6. Repeat step 5 until the password is entered. When you press Enter for the fourth digit, a
secure run mode or secure setup pop-up will appear as confirmation. Once set, the field will display
“Enabled”.
7. Once enabled, follow one of the scenarios below:
For Secure run mode to occur, navigate to one of the measurement screens and press the
Run key. A “Secure Run Mode” screen will appear.
For Secure setup mode to occur, navigate to the setup screen and the “Secure setup mode”
screen will appear.
To Next Page
Loading...
Need help?
General
