Setting
Setting RFID interfaces via the web server
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | more@turck.com | www.turck.com
07.00 | 2022/09 | 179
Example: Executing a command in bus mode
In the following example, the read/write head with address 2 is to read 8 bytes from a tag in HF
bus mode. Two read/write heads are connected to channel 0 of the interface.
Click Local I/O Ò Parameter in the navigation bar on the left of the screen.
Select RFID channel 0.
Select HF bus mode from the Operation mode drop-down menu.
Activate connected read/write heads 1 and 2.
Click Write to write the set parameters to the device.
Fig.89: Reading tags in HF bus mode — parameters
To Next Page
Loading...