Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Page 107

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 3-49
Privileged Mode
show log
Use the show log command to display the current events on the system.
Syntax: # show log {firewall|pri|sip|system|t1 port|lcc number}
[severity]
Example: adit 3500# show log t1 1 minor
System Log Message Jan 1 00:00:08 2003 kern.err T1 ALARM: Alarm LOS T1#1 Major received
System Log Message Jan 1 00:00:04 2003 kern.err T1 ALARM: Alarm LOS T1#1 Major received
System Log Message Jan 1 01:19:13 2003 kern.err T1 ALARM: Alarm LOS T1#1 Major received
System Log Message Jan 1 00:57:12 2003 kern.err T1 ALARM: Alarm LOS T1#1 Major received
System Log Message Jan 1 00:56:52 2003 kern.err T1 ALARM: Alarm LOS T1#1 Major received
System Log Message Jan 1 00:56:34 2003 kern.err T1 ALARM: Alarm LOS T1#1 Major received
System Log Message Jan 1 00:56:09 2003 kern.err T1 ALARM: Alarm LOS T1#1 Major received
System Log Message Jan 1 00:00:04 2003 kern.err T1 ALARM: Alarm LOS T1#1 Major received
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
firewall Filter firewall alarms
pri Display PRI logs. Note: This is not supported on the Adit 3104.
sip Display SIP logs.
system Filter general system alarms
t1 port Display event log for a specific T1 port.
Adit 3104: Value must be 1.
Adit 3500: Range = 1-4.
lcc number Display event log for a specific Link Cross-Connect (LCC).
MSR: Range = 1-8.
severity alert - Filter alert alarms (threshold crossing)
all - Display all alarms.
critical - Filter critical alarms (service affecting)
info - Filter informational alarms
major - Filter major alarms (service affecting)
minor - Filter minor alarms (non-service affecting)