Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - No Commands

8-8 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Dial Peer FXS Mode
no commands
no block-out-caller-id
Use the Dial Peer no block-out-caller-id command to disable the Caller ID blocking. To enable
blocking, see block-out-caller-id command on page 8-2.
Syntax: (config-dpeer-fxs)# no block-out-caller-id
Example: (config-dpeer-fxs)# no block-out-caller-id
Supported Platforms:
Adit 3104, Adit 3500, MSR
no call-wait-caller-id
Use the Dial Peer no call-wait-caller-id command to disable Call Waiting Caller ID. To enable
these calling features, see call-wait-caller-id command on page 8-2.
Syntax: (config-dpeer-fxs)# no call-wait-caller-id
Example: (config-dpeer-fxs)# no call-wait-caller-id
Supported Platforms:
Adit 3104, Adit 3500, MSR
no call-waiting
Use the Dial Peer no call-waiting command to disable Call Waiting. To enable Call Waiting, see
call-waiting command on page 8-2.
Syntax: (config-dpeer-fxs)# no call-waiting
Example: (config-dpeer-fxs)# no call-waiting
Supported Platforms:
Adit 3104, Adit 3500, MSR
no calling-party-disc
Use the Dial Peer no calling-party-disc command to disable Calling Party Disconnect. To enable
this feature, see calling-party-disc command on page 8-2.
Syntax: (config-dpeer-fxs)# no calling-party-disc
Example: (config-dpeer-fxs)# no calling-party-disc
Supported Platforms:
Adit 3104, Adit 3500, MSR