Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - No Dial-Peer Voice Voip; No Dynamic-Dns

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-39
Global Configuration Mode
Global Configuration Commands
no dial-peer voice voip
Use the no dial-peer voice voip command denies access to the Dial Peer Voice VoIP configuration
commands. To allow access, see dial-peer voice command on page 4-11.
Syntax: (config)# no dial-peer voice voip tag
Example: (config)# no dial-peer voice voip 1
Supported Platforms:
Adit 3104, Adit 3500, MSR
no dmz-host
Use the no dmz-host command to remove a DMZ host. To add a DMZ hose, see dmz-host
command on page 4-12.
Syntax: (config)# no dmz-host address
Example: (config)# no dmz-host 10.10.200.1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no dynamic-dns
Use the no dynamic-dns commands to disable DNS Dynamic entries. To enable DNS Dynamic
entries, see dynamic-dns command on page 4-14.
Syntax: (config)# no dynamic-dns {backup-mx|interface|mail-exchanger
|offline|wildcard}
Example: (config)# no dynamic-dns backup-mx
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
tag Enter the tag number to denies access. Range is 1-30.
Field Definition
address The IP address of the DMZ host.
Field Definition
backup-mx Disable DNS Dynamic Backup MX.
interface Specify DNS Dynamic connection to update.
mail-exchanger Remove mail exchanger.
offline Disable DNS Dynamic offline.
wildcard Disable DNS Dynamic wildcard.