CHAPTER
13
Configuration - Serial Interface Mode
The Serial Interface Configuration commands allow the user to configure the serial interface
parameters.
Enter this sub-group with the (config)# interface serial number command from the Configuration
mode.
The Serial Interface commands are represented by the (config-int-ser-{n})# prompt.
Note: Before configuring serial interface parameters, you must enable PPP encapsulation on the
interface using the encapsulation ppp command.
Serial Interface Commands
• description • ip ospf disable • no commands
• do • ip ospf hello-interval • ppp authentication
• encapsulation ppp • ip ospf message-digest-key • ppp encryption
• end • ip ospf priority • ppp exec-timeout
• exit • ip ospf retransmit-interval • ppp link-fragmentation
• firewall • ip ospf transmit-delay • ppp on-demand
• history • ip primary-dns • ppp password
• ip address • ip rip • ppp restart-timer
• ip default-route • ip route • ppp time-btwn-reconnect
• ip mtu • ip route-mode • ppp username
• ip ospf authentication • ip secondary-dns • schedule-availability
• ip ospf authentication-key • metric • shutdown
• ip ospf cost • multilink-group • sip-alg
• ip ospf dead-interval
To Next Page
Loading...