Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Port-Trigger Service; Pptpc; Pptps

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-53
Global Configuration Mode
Global Configuration Commands
port-trigger service
Use the port-trigger service command to configure the port-triggering entries. To delete a port trigger
service, see no port-trigger-service command on page 4-45.
Syntax: (config)# port-trigger service name enable
Example: (config)# port-trigger service service2 enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
pptpc
Use the pptpc command to allow access to the VPN PPTP Client configuration commands. See Chapter
17, Configuration - PPTPC Mode for commands in this mode. To delete an existing connection, see no
pptpc command on page 4-45
Syntax: (config)# pptpc {pptpc connection-id|address address}
Example: (config)# pptpc pptpc 1
(config-pptpc-1)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
pptps
Use the pptps command to allow access to the VPN PPTP Server configuration commands. See
Chapter 18, Configuration - PPTPS Mode for commands in this mode.To delete an existing connection,
see no pptpc command on page 4-45.
Syntax: (config)# pptps
Example: (config)# pptps
(config-pptps)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
name Enter service name.
Field Definition
connection-id Enter the name of a connection. Range is 0-99.
address Enter a destination IP address.