Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Ppp Authentication; Ppp Encryption; Shutdown; 12 Configuration

To Next Page

To Previous Page

CHAPTER

Configuration - Multilink Interface Mode

The Multilink Interface Configuration commands allow the user to configure the MLPPP parameters.

Enter this sub-group with the (config)# interface multilink number command from the Configuration

mode. The Multilink Interface commands are represented by the (config-int-mlink-{n})# prompt.

Note: Before configuring MLPPP parameters, you must create a multilink group from the

corresponding Serial interface. Use the multilink-group command to create the group.

Multilink Interface Commands

• description • ip rip

• do • ip route

• end • ip route-mode

• exit • ip secondary-dns

• firewall • metric

• history • no commands

• ip address • ppp authentication

• ip default-route • ppp encryption

• ip mtu • ppp exec-timeout

• ip ospf authentication • ppp link-fragmentation

• ip ospf authentication-key • ppp on-demand

• ip ospf cost • ppp password

• ip ospf dead-interval • ppp qos-interleaving

• ip ospf disable • ppp restart-timer

• ip ospf hello-interval • ppp time-btwn-reconnect

• ip ospf message-digest-key • ppp username

• ip ospf priority • schedule-availability

• ip ospf retransmit-interval • shutdown

• ip ospf transmit-delay • sip-alg

• ip primary-dns

Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Ppp Authentication; Ppp Encryption; Shutdown; 12 Configuration - Multilink Interface Mode