Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - No Idle-Time

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 18-5
Configuration - PPTPS Mode
no commands
no idle-time
Use the PPTP Server no idle-time command to reset the idle time to the default setting. To set the
maximum idle time for a PPTP connection, see idle-time command on page 18-4.
Syntax: (config-pptps)# no idle-time
Example: (config-pptps)# no idle-time
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ppp authentication
Use the PPTP Server no ppp authentication command to disable PPP authentication. To enable
PPP authentication, see ppp authentication command on page 18-6.
Syntax: (config-pptps)# no ppp authentication {chap|ms-chap|
ms-chapv2|pap}
Example: (config-pptps)# no ppp authentication
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ppp encryption
Use the PPTP Server no ppp encryption command to disable PPP encryption. To enable PPP
encryption, see ppp encryption command on page 18-6.
Syntax: (config-pptps)# no ppp encryption {40-bit|128-bit|stateful}
Example: (config-pptps)# no ppp encryption
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
chap Support Challenge Handshake Authentication (CHAP)
ms-chap Support Microsoft CHAP (MS-CHAP).
ms-chapv2 Support Microsoft CHAP Version 2 (MS-CHAPv2).
pap Support an unencrypted password. Default.
Field Definition
40-bit MPPE-40 - Microsoft PPP encryption algorithm.
128-bit MPPE-128 - Microsoft PPP encryption algorithm.
stateful Enable the stateful state for encryption.