Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Ip Rip; Ip Rip Enable; Ip Rip Receive Version; Ip Rip Send Version

11-14 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Ethernet Interface Mode
ip rip
ip rip enable
Use the Ethernet Interface ip rip enable command to enable RIP on this interface. To disable RIP,
see no ip rip command on page 11-21.
Syntax: (config-int-eth-{n})# ip rip enable
Example: (config-int-eth-1)# ip rip enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip rip receive-version
Use the Ethernet Interface ip rip receive-version command to configure the RIP receive messages
on this interface.
Syntax: (config-int-eth-{n})# ip rip receive-version {1|2|1or2|none}
Example: (config-int-eth-1)# ip rip receive-version none
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip rip send-version
Use the Ethernet Interface ip rip send-version command to configure the send RIP messages on this
interface.
Syntax: (config-int-eth-{n})# ip rip send-version {1|2-bcast|
2-mcast|none}
Example: (config-int-eth-1)# ip rip send-version 2-bcast
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
1 Receive RIP version 1
2 Receive RIP version 2
1or2 Receive RIP version 1 and 2.
none Set RIP version to none.
Field Definition
1 Send RIP version 1.
2-bcast Send RIP version 2 - Broadcast.
2-mcast Send RIP version 2 - Multicast.
none Set send RIP version to none.