Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - L2 Tpc

4-26 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
key
Use the key command to enable a specific keyed feature. To acquire a feature key code, contact Turin
Networks Customer Support. To disable a keyed feature, see the no key command on page 4-43.
Syntax: (config)# key key-code
Example: (config)# key q0B8yma2IsSL+1BarY0u
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
l2tpc
Use the l2tpc command to allow access to the VPN L2TP Connection configuration commands. See
Chapter 15, Configuration - L2TPC Mode for commands in this mode. To delete an existing connection,
see the no l2tpc command on page 4-43.
Syntax: (config)# l2tpc {l2tpc connection-id|address address [ipsec
local-secret secret] [local-secret secret]}
Example: (config)# l2tpc l2tpc 1
(config-l2tpc-1)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
key-code
Enter the key code to enable the feature.
Field Definition
connection-id Enter the connection ID (number).
address Enter the IP address of the destination.
ipsec Optional parameter. Directs IPSec to create an L2TP connection.
Requires the local-secret option.
local-secret secret Optional parameter. Enter a secret password used to authenticate
L2TP connection. Maximum number of characters is 96.